Expose as Starter parameters

Understand the different ways of exposing parameters

This feature allow to quickly activate / load / unload elements.

To access this feature just do a right clic over the activation or opacity of a layer.

Then you can either choose “expose as starter parameter” or “expose as automatic starter parameter:

• Expose as starter parameter will result in the creation of an exposed parameter going from 0 to 100%.

This exposed parameter will control load / activation / opacity of a layer behave as follows:

0%-2%: load / unload layer

2%-3%: activate / deactivate layer

3%-100%: Change layer opacity from 0% to 100%

• Expose as automatic starter parameter will create a Boolean parameter (on / off button) that will have the same behavior as a starter parameter but set in min/seconds/frames instead of percentages: